Measurement Protocol
Follow our system for roller & zebra blinds precision
Requirements
Measuring Tape
Cloth or steel variants
Pen & Paper
For recording data
Ladder
Stable access to heights
Familiarization Protocol
Units
Centimeter (CM)
Measure to the nearest MM
Tape placement
Flat front-facing jamb
Avoid beveled edges
Standard format
Width x Height
Always note in this specific order
Methodology
Inside vs Outside Fit
Choose based on mounting space
Critical Rule: Do not transpose Width & Height values. Accuracy is non-negotiable.
Method 1
Exact Fit (Inside Mount)
"Measurements shall be taken inside edge to inside edge of the opening or up till the outside to outside edge of the window frame."
Blinds are installed within the opening, utilising the available wall depth.
Provides a neat, flush finish aligned with the window/door frame.
Method 2
Recess Fit (Outside Mount)
"Measurements shall be taken beyond the outer edge of the opening or the window frame."
Blinds are installed outside the opening, covering the frame/wall surface.
Ensures maximum coverage, light blockage, and privacy.
Protocol - For Both Exact & Recess
Width (W)
Measure at top, middle & bottom points
Example: Wt = 127.50 CM; Wm = 127.00 CM; Wb = 127.30 CM
Choose Minimum Width - W = 127.00 CM
Height (H)
Measure at left, center & right points
Example: Hl = 146.50 CM; Hc = 147.00 CM; Hr = 146.50 CM
Choose Minimum Height - H = 146.50 CM
Zero Manual Calculation
No manual calculations required — just enter [minimum] width x height measurements on the order page. Our system handles the complex geometry and tolerances.
Pre-Order Caution
All blinds are custom-made based on your unique dimensions. Production starts immediately.
Final Verification
Check all parameters before committing
Need Consultation?
Our technical team is ready to assist with complex architectures or mounting queries before you finalize your order.